flip32 - cant seem to arm board

7

7808

Member
hello
just built my 2nd quad on an ebay 250 frame. 12a ready to fly quads ESCs and 2300kv motors flip32 board from witespy

all ive done so far in baseflight is calibrate my escs ( I think it worked) check the receiver, checked the motors using motor test to make sure they work and spin the right way.
im using a flysky fs ct6b tx fs r6b rx (same as cheap hk 6ch tx rx)

I have 1-4 connected to inputs 1-4 , everything seems to be fine in the receiver tab on baseflight. only thing I can think of is I cant get my throttle to sit at 1000 its around 1028 all the way down.
maybe I missed some other configuration step?

also im not exactly sure how to setup auto level.
 

C

cootertwo

Member
http://witespyquad.gostorego.com/videos.html

I'd look at this page first. Lot's of info, settings, etc. etc. Throttle end points are critical on a lot of controllers. I know how frustrating it is to spend hours building a quad/hex, and having unknown problems, "at first". My biggest problem is that half the time, I correct the problem, but can't remember what I did, to correct it! You'll get her going. If they were 100% plug and play, I'd get bored real quick.
 


7

7808

Member
well you were right, I did something, not sure what. got it going. still trying to figure out auto level
 

You must log in or register to reply here.
Top