resourcewiz
New Member
I received a Fimi A3 Drone a few days ago as a holiday gift. So -
· Unpacked the box
· Charged the drone battery
· Charged the RC
· Attached the propellers in their correct positions
· Downloaded the manual and read it over
· Calibrated the various settings
I turned on the drone and RC. I had video reception on the screen, so the drone’s camera was sending a signal to the radio controller’s screen. However, when I pushed both sticks to the inner notched positions to start the propellers spinning, the propellers did not spin. The sticks were held to the inner positions for over three seconds but no movement from the propellers.
Is this drone defective or is there another step that I need to do?
· Unpacked the box
· Charged the drone battery
· Charged the RC
· Attached the propellers in their correct positions
· Downloaded the manual and read it over
· Calibrated the various settings
I turned on the drone and RC. I had video reception on the screen, so the drone’s camera was sending a signal to the radio controller’s screen. However, when I pushed both sticks to the inner notched positions to start the propellers spinning, the propellers did not spin. The sticks were held to the inner positions for over three seconds but no movement from the propellers.
Is this drone defective or is there another step that I need to do?