DX6i + X1 remote gain adjustments NAZA

N

nosedive

Member
I am not sure if what I am trying to do is possible but using a dx6i I am trying to set up remote gain on the naza. This will be on a 2 way switch as the tx does not have a knob.

I have 1 spare channel after setting up the gear channel to control the ATTI/MANUAL modes.

I plugged in last AUX port from the reciever to the X1 port on the naza. Connected to assistant but switching the switch or changing the travel adjust end points for this channel does not move the slider on X1. I tried going through calibration again but nothing.

Any ideas? Is this possible?

Do you have to have both X1 AND X2 connected for remote gain to work?
 



N

nosedive

Member
Close this thread I figured it out. The travel adjust end point wasnt moving the x1 slider. I had to go into the flaps menu on the dx6i to set the end points, and the x1 slider moves.

Now set up so I have a high and low atti gains setting on a switch, works great.

Still learning!!
 

You must log in or register to reply here.
Top