Djif450 mega ez 3.0 build

[gregrob]

Just wanted to share a few pics and vids. More to come! I did 4 flights today total and all went mostly well. Getting a feel for it and going to start doing some PID tuning. It's stabilizing pretty well but the "rudder" or yaw is really slow.

Full throttle punch outs are INSANELY fast. It has tons and tons of horsepower and that's with what I would call small props especially for my altitude? (6,000ft ASL)

Specs are:
-F450 flamewheel
-Mega EZ 3.0
-Ublox GPS
-Bluetooth Configuration Module
-Sunnysky 2216 1100kv
-Fire Red Series ESC Simon K - RapidESC
-Turnigy 4s 3000mah
-APC 9x4.5 props
-Frsky Taranis and X8R

Thanks for looking!

This landing gear was off of some other copter. Very flimsy and didnt last long at all.

My first bad crash, destroyed the frame, arms, and battery but salvaged all the other parts, moved to a cheap neewer frame from amazon but it works good. I tried to flatten out this battery by hand and it exploded!

The Mega board, soldered on right angle pins for the bluetooth module

BT Module

I tried the crab legs from amazon and those worked pretty good but I broke them too. Now I'm running the diy carbon fiber landing gear from goodluckbuy. This is the way the quad sits now.

 

[gregrob]

First real flight other than just a 3ft hover
https://www.youtube.com/watch?v=jhg_VSygTc8

First time with a gopro on front
https://www.youtube.com/watch?v=AuCEnBZh_lk

Added some LED strips to the back.
https://www.youtube.com/watch?v=6Dpvj2lTup0