flipporabasta
Member
Hi
Need some advice regarding the placement of ESC and PowerDistributionBoard.
I have a Tarot FY690S frame, and i bought the Gryphon Power Distribution Board (GPD-1000HXP). The board was a bit bigger than i thought so im not really sure about the best placement for it. And i have been thinking alot if i am going to place the ESC on the arms near the motor (no need to extend any motorables, but it requires resoldering of the ESC's powercables and servocables) OR on the HUB itself (not much space there to fit many things). dont want the hexa to look like a spiderweb when im done.. i like clean installations.
The rest that is needed to be fitted on the thing is, Naza V2 + gps + BTU module, and of course LiPo's (but that has only 1 place to be fitted :02.47-tranquillity
+ videotransmitter
Any items i dont know of for the tarot, that would make fitting things nicely easier?
any suggesstions is appreciated.
//Micke
Need some advice regarding the placement of ESC and PowerDistributionBoard.
I have a Tarot FY690S frame, and i bought the Gryphon Power Distribution Board (GPD-1000HXP). The board was a bit bigger than i thought so im not really sure about the best placement for it. And i have been thinking alot if i am going to place the ESC on the arms near the motor (no need to extend any motorables, but it requires resoldering of the ESC's powercables and servocables) OR on the HUB itself (not much space there to fit many things). dont want the hexa to look like a spiderweb when im done.. i like clean installations.
The rest that is needed to be fitted on the thing is, Naza V2 + gps + BTU module, and of course LiPo's (but that has only 1 place to be fitted :02.47-tranquillity
+ videotransmitterAny items i dont know of for the tarot, that would make fitting things nicely easier?
any suggesstions is appreciated.
//Micke