pixhawk

Benewake TF03 LiDAR can directly be connected with the serial port of Pixhawk. TF03 can be used in flight device for the purpose of altitude holding or obstacle avoidance. This document is suitable to Pixhawk adopts ArduCopter V3.6.2 or higher firmware(Note:Standard output mode should be used...

Install TF SERIES module on your drone vertically to the ground so you can get the absolute altitude of your drone. Here is how to install our module on PixHawk. We provided two methods below. 1. How does TF SERIES work on PixHawk Lidar’s are used in flight modes which have height control...

Hi guys, for all of you that would like to start from scratch bulding a drone, I warmly suggest to install the Micro PIX4: 32 bit, open source, same Pixhawk family, tiny and light. I've just complete my build and still have to fine tune it but it is already very stable: