betaflight

Hello I am no expert in drone builds having only been building for about 2 years, and only on my 3rd build. I have a question for anyone who has experience with resource remapping. I lifted a motor pad on a betaflight f4 board and there is no apparent wire that I can scrape off to get a...

Greetings! I am new to the drone building world. I have had some experience with RC but nothing like this. I have run into an issue trying to setup my channel mapping. I’m using beta flight, Spektrum tx/rx, Dx6e, with TBS powercube. I’ve got to the point trying to ensure my channels are mapped...

Hey guys, Sorry if this isn't the appropriate place to start this thread. I'm not very familiar with these forums. Anyway, I recently finished building a custom V Tail quad and I am using iNAV on the Omnibus F3 as the flight controller and firmware. The problem is that I cannot seem to get the...

Just set up a new Seriously Dodo FC in Betaflight. Calibrated motors and ESCs (flashed with latest BL Heli with OneShot 125 set) which are responsive to Master and individual slider commands in Betaflight and spinning direction is correct. Receiver settings in Betaflight look good - all...