Search results

Unfortunately GH4 will record 4K footage with maximum 100mbps, not 200mbps as in Full HD (1920x1080).

This thread is dead. By the way, there is a bug in your software. It cannot completely reset settings to default.

Permission is denied

2 George: You promised me to send email about picloc replacement. Please don't forget about me

Can you post here the default PID settings for nick/roll/yaw? I have messed up there and for some reasons even after gimbal reset it restores back to my changed values. What's algorithm and best practices of setting PID for HoverFly gimbal anyway?

George, I'm waiting for picloc swap too. #124 Still no email from you,

I'm in first 200 for picloc swap. Btw do you have new :) estimate date for picloc swap?

2MombasaFlash - Thanks for your help. I have tried flying with picloc mounted off-axis but I wanted to try to install it on the plate. As I understand now it'll work only with 360 servos. To George I made a mistake today and connected plus and minus to picloc vice versa. There was a click...

I have solved problem with non focusing this summer - yes, by switching to manual focus. But still I have the problem, when I start shooting, I need to press the shoot button for several seconds to get the first shot.

Hi I have the same problem with my nex5n When I have hdmi cable connected, camera makes 70% less photos. I have to keep pressing photo trigger on my remote control for several seconds to make that photo.

I have tried to place picloc both ways - arrow to the nick direction and arrow to roll direction, the same result. I have disabled transmitter control for tests. Tried both prop and slew settings. Magnitometer is disabled. I try to control 2 axis for now, but none of them work.

I can't make picloc installed on plate work. When I tilt copter 30 degrees, picloc compensates only 5-10 degrees. When I try to increase 'Proportional' parameter in gains, the plate start going back and forth very often, so I have to decrease it. I have belt with 1:4 ratio on both of tilt and...

What new clips are you talking about? Those ones from Nov 2011?

I have installed picloc on the camera plate and cannot make it work. firmware: 56.76 X1, settings are: hierarhy: pan/roll/tilt, tilt in arrow direction, servo ratio 1:4 Savox 1290MG The problem is I can't increase P enough to compensate tilt. Here is what I try to do: I have laser level...

2 PaNt : Please clear your PM box. I can't send you a private message.

GeorgeM: Yes, ratio is 4:1

Actually these are not slow servos. They are Savox 1290MG powered with 7.5volts via UBEC from 3S lipo. But I couldn't make it work with X1 version of firmware.

Firmware - 2012_04_29_P3X_v56_76_PRO_X3.hex (X3 - for slow servos) Servos with external potentiometers

Is this a good Picloc performance? Or it needs further tuning with PID?

Hi George We talked via email two weeks ago. I sent you a couple of emails recently. Can you check your email again? - Alexey Danilin