Search results

Ironic, i fighting the same problem right now, and just jumped on the internet to research! You are correct, it's com 1, with white signal to the top. I have the exact same problem as you, and have tried 3 pc's with the exact same result, nothing happens after a restart. Very frustrating, I have...

I have the e300 on two tbs frames, one with naza v2 and one with zerouav ys-x6. These replaced the original tbs motors with 9" graupners. in both cases, I find a much more steady flight characteristic, both frames feel more locked in. I use these combinations for mild fpv, not aerobatics, and...

Was an issue with the mission planner software. Resolved this morn. Version 1.3.4 now available.

Fly away In my case, purchased ys-x6 just before P version was released. Wifi setup easy, but android phone app would not accept changes, but installing app on tablet worked fine. Frame is a qav500, and it did require tweaking to remove a terrible "stutter" at launch. Other than that, unit flew...

Look 4 posts up, had what may be a similar problem in that the init button would not work on my note2 phone. Everything else worked perfectly but that one button. May be a wild guess, but can you try the same process on another device to see if it will send? That's what worked for me.

Uncontrolled Flight I have flown this multi very successfully for some time, but yesterday the multi took off by itself. Here is what happened: Was flying in GPS mode. Switched to position 2 to go into Altitude mode. As soon as the switch happened, the multi tilted to 45 degrees forward, and...

Thank You holco. I have been using a Samsung Note 2 phone for the android app, and your reply prompted me to think it was this phone that would not let me init settings. I installed the app on a Samsung Tab just now, and it works as expected! In reply to your comment on esc calibration, I had...

Enable Setting - how? Folks, can someone explain how to "Enable settings, change below parameters" found on the 3rd page of the "Param tab in the android app? I want to change the value in the Volt Alert Threshold, but for the life of me don't understand how to follow the yellow text at the top...