Search results

Are you providing power to the NAZA? Power is separate from the USB data link. Sent from my iPhone using Tapatalk

Little bit of a necro here, but i already purchased some 1300mAh 2S turnigys that HK had on super cheap day. Sent from my iPhone using Tapatalk

Update: as suggested the ET600 was not putting out 5V, more like 4.2V. The camera just wasn't getting enough juice. So I rewired the camera to run off of the balance port on my 2S FPV battery. System works!!! I'm so excited to fly this sucker. What's the deal with all the different camera...

Per the camera spec, it supports 5-17V. I'm at a loss, other than the camera just being busted. Sent from my iPhone using Tapatalk

Yeah, when everything is new it's hard to identify a point of failure. However, once it's up and running, swapping in new stuff would reveal if they are broken. Sent from my iPhone using Tapatalk

Yeah I might just carry it all down to my local hobby shop and see if they have any parts I could drop in the system to see what's wrong. Sent from my iPhone using Tapatalk

Lens cap has been removed. I'm at a loss for what to try next. Sent from my iPhone using Tapatalk

So I just got my whole thing setup. I'm powering the camera through my Eachine ET600, which is transmitting to my Eachine EV800. I can access the settings for the camera through the included remote. However I get no video. Sent from my iPhone using Tapatalk

I don't think so. They are your standard jst-xh balance connectors. I have a 2s Turnigy battery I'm using on my FPV gear Sent from my iPhone using Tapatalk

Correction: the housing is female, I think it has the male pins though. Sent from my iPhone using Tapatalk

They are JST-XH, I need the female connectors. Sent from my iPhone using Tapatalk

So I recently purchased the aforementioned video transmitter. The included power plug is a 3s balance plug, but only has two wires leading to the board. I'm assuming they come from the first and last pin to draw the full power of the battery. I purchased a 2s battery to power my FPV gear and...

The only other thing I can think of the is the inherent difference in the material properties of ABS verses Carbon Fiber. Sent from my iPhone using Tapatalk

Did you change prop length as well? I know different size batteries (3S/4S) perform better with different prop lengths. Also, did you balance your new props? Sent from my iPhone using Tapatalk

This might be a bit of a dumb question, but what is the difference between "1x" and "!1x" under the Special Functions -> Play Track frequency options?

What is the connector standard on this headset? I just recently ordered a pair and would like to go ahead and order some cloverleaf antennas for them. The only problem is I don't know if the headset is SMA or RP-SMA? Also, what are the recommended antenna combos? Like a 4/4 cloverleaf? A 3/4...

I think I am going to go the secondary battery route for now, if I find the flight time to be poor I might order those BECs and run them off the PDB. Thanks for all your help.

Does the BEC you linked include an LC filter? The banggood page doesn't mention it. Also, there's no wiring diagram, in the main picture, whats the left side 12V for?

I knew I should have paid more attention to my Electrical class. Thought I wouldn't need it, being a Mechanical Engineer

Is 2200 mAh too large for an FPV setup? Also, what about the EM field generated by an LC filter? Do I need to shield the filter from the antenna?