Search results

Attached is a picture of how the setup looks now. I have tried to set it up again with no luck! From the upgrade board (left of the picture) there are 4 cables coming out Red which I assume is power Yellow which I assume is video 2x Brown which I assume are Grounds Is this all correct? I...

The unplugging of the other ground that goes side by side with the video cable yielded no success, I still can't figure out why I am getting a black screen but no signal from the gopro... Here are the pics of the wiring in case someone spots something wrong... Thanks guys!

so to sum up you suggest only having a ground paired with the power cable, side by side going into the Tx, but not the brown one that goes next to the video yellow cable right? It's a good thing that you state the obvious, there must be a lot of people forgetting some minute detail that makes it...

Thank you for the info CdA D, but in my case the Tx came set at channel 1, which I have not changed, but you gave my thoughts exactly, getting a black screen instead made me think of a correct connection between the Tx and the Rx but no input from the camera, which can mean two things, either...

Actually that is not it. I am in Spain and therefore working with PAL settings, I did change it just to try out, but went back to Pal with no success... I am waiting to get home and change the cable to the Zenmuse, which took a hard crash last week after getting the props caught in a flag while...

I will post pictures tonight when i get home. The camera is powered on and the transmitter has the light on. I did not change the default channel setup, I was just making the point that it could be changed as per the printout that comes with the VTx from ImmersionRc. On the VTx there are two...

Thank you for the input, but that is not the problem, I checked and the channel on the 600mw Tx can be changed and I did accordingly to the chart provided by ImmersionRc on the Tx packaging. Also checked which band the Tx operates on in order to match it with the monitor, and it appears it does...

Hey guys, need some help over here. I have the following fpv setup, for which I will post photos later so you guys can see the wiring. I hope someone can find the problem and solution for me, as I cannot get this to work as intended. I have a phantom 1 with an upgrade board for the zenmuse...