Search results

thank you. :) I will try there also.

Hello guys :) I am building my first quadcopter and while I was configuring the software via Mission Planner i noticed the "Bad GPS health" message.I was looking into the reason and i found that it is probably caused by the old firmware.I saw on Ardupilot downloads page the "pass through" hex...

Hello again in the few days i was reading about the 433mhz modules.As far as i understood people are recomending a dipole antenna for the ground module.I also undestood that i will need a low pass filter for 433mhz so i can protect the higher frequencies such as the fpv system ,GPS and radio.So...

Thank you for the site provided it looks very helpful i will look at it more detailed tomorrow.In the mean time i saw this 2 posts originally posted in rcgroups. Which is obvious because on hobbyking is written "FrSky V8FR-II 2.4Ghz 8CH Receiver (HV)" not "FrSky V8FR-II 2.4Ghz 8CH Receiver...

ohh...I'm sorry for the stupid question i didn't see it:shame:.. I was looking for a battery for the turnigy 9x and i saw that this one fits(unless i missunderstood something) but it says "LLF" what is that?Can i charge it with the charger i have chosen? Oh and i read in the rc forums that the...

little update: charger power supply parallel connection for the charger new power distribution board (i think its good enough), by the way is it absolutely necessary to solder the ESCs to the board?It looks so nice with the connectors...:nevreness: Quick question does the portable display have a...

Hello.Do you mean telemetry kit antennas?If so i don't know if they are reverse polarity or not i have to look.The 3s battery is going to be used for the fpv system as i said in my previous post.I also listed a BEC which is going to be used to supply my FC(Arduflyer 2.5.2),gps,telemetry ,OSD and...

Hello again, So first here is a wiring diagram of the quad electronics(it might have made a mistakes somewhere i draw it very quickly and amateur :nevreness:) the parts i am thinking of using: frame Motor ESCs - i am changed them because this ones have crystal oscillator(as far as i undestood)...

I found my answer it's called guided mode here is a link to it (the bottom of the page).Ok i think i know everything i need for now.In the next few days i will try to come up with what exactly i want the quadrotor to do,what parts i like for achieving this purposes and the way i will try to...

Thank you for your answer, but i think that we are having a miscommunication.I know where telemetry comes from:) i was asking if i can connect a telemetry kit with a pc/tablet/phone and program a gps waypoints while the quadrotor is in flight.:) I already saw how i can connect telemetry and osd...

Hello again sorry for the delayed answer, :) If by fast shoot you mean to fly fast and aggresive i can assure you that i won't use it for that.I am just a newbie i will use it just to get used to fly a multirotor with camera.:)But lets put the camera aside for a while i will decide what to be...

slow_jun about the gopro they are too expensive and i read that there is a delay in the fpv when using a gopro as fpv camera. :) After some more browsing i think i will probably go with the boscam explorer hd 19 it is only 58 grams, the quality seems good enough and it has a build in onboard...

I am pretty sure that it will be legal about the frequency. About the 1.3ghz i wanted to be on that frequency, but then i saw in these videos(i watched them before starting the thread :) ) that your FPV frequency must be over your radio frequency unless you want to make filters and such.Then i...

hmm nice technology that pixim.. :)if the quality is like in the pictures shown i think i just changed the camera of my quad hehe.Sure it will probably need some soldering , but i can handle that.About the frequency i already checked the 5.8Ghz is in the radio amateur spectrum here in Bulgaria...

I will probably go with this setup, if it hovers at too high trottle i will change the propellers to 12x4.5 i will loose 1 minute of flying time but the trottle will be at about 51% or 5% less. About the FPV what do you think about this setup: 1.Camera 2.OSD 3.TX 4.RX 5.Antenas 6.Battery Is...

Hello again guys, :) 1st i want to thank you for your time.Motopreserve yes i might have missundestood my english is not so good,but from what i undestand from your post you mean that this camera is not for photography it is for fpv i know that i guess i will postpone the photography for couple...

Hello Motopreserve :) , thank you for your time and suggestions. About the aerial photography yes i know that with this camera i won't get far,but i want to start with something less expensive,because i don't want to spend too much money for my first build which i will most likely crash.I am...

Hello guys, after good information drilling , i decided that i will be capable of building my first quadcopter.I'm sure i will need help at some point, so i'm starting a thread to ask you, the exp. guys, if i have any troubles. I hope you will help me I want to build quadcopter with as long as...