Search results

Hi i sell all this props ..PM for info PayPal accept send worldwide with DHL or Local post..thank you

actually by using GPS or ATTITUTE MODE in not very wind conditions frame is very unstable and i have roll oscillations also my vertical descent is bad ...right now i will change flight controllers and i will fly this frame using Hoverfly Pro controller.. after that i will post my impressions...

I would like to thank you all for your help ... there is a delay in my reply due to time difference ... I believe the same company give me an answer .. I notified them by email and I hope answer me soon . . again thank you.

Hi ! I bought 2 months ago the following product Naza-M V2.. I have a hexacopter heavy lift (TAROT 960 Frame ) weighing 6 kg ... propeller 16 * 5.5 APC Motor TAROT 340 Kv 30 AMP ESC and 6 cell battery .. in good and calm weather flies very well. ., but with a little air is completely unstable...

i like to say after all ..that Hover fly board manage very well my hexa with al most one motor out of duty..and new firmware is very safe to fly !!

Pavlos are ESC are RCTimer HVSK-40A High Voltage OPTO Brushless ESC .

first only hovering flight and i found a ESC with problem..after Raising the throttle the motor starts turning like crazy ...and perhaps this is the my problem.

:tennis: ha ha ... if continue the same problem .. will begin flying a new way and will call ....3d flying and dancing in the air !!!

Pavlo...i am using a DPCAV Power Supply Filter, L-C Type str8 from battery but..also from the same output i had connect voltage for fpv camera and video transmitter ..so maybe that was the problem ..now everything is connect separate from each other .and will see tomorrow with the flight test...

First of all i like to thank ..any one here for help and for your interest .. but mostly I want to thank HF team that response directly to my problem and give me a image about what can be the problem..as IrisAerial say in previews post i have to check the power to my board..something cause...

ESC are RCTimer HVSK-40A High Voltage OPTO Brushless ESC and and i will check again tomorrow for radio i have AR8000 ... Also waiting news from HF team as hope to read and explain the Flight log.

Tim..very bad news ..I am starting to lose my patience. Is in the air for 3 minutes perfectly and then it starts to turns around by himself .. I figured out how to control it but this can not be continue.i must found solution right now.

flight log sent

one more flight to day and...it happent again this time with the old firmawere...that meens something else going WRONG ..i have flight log ..so please HF team Help me to find what is the problem.....:upset:

hi ! I have black Board.

Paul i was very lucky this day...i flight with a 7inch display so I had the opportunity to look at the same time monitor and model .. I tried not to lose my temper and when I saw that it was falling vertically then I said to myself that I would landing ... the worst was a half minutes of my life...

i have AR8000 receiver ..distance was 100-120 meters 80 meters altitude..never have problem with signal...on board i have 2 battery checker with very loud sound for safety ...my fail safe is middle position for throttle so if signal lost my ship stay in hover ...

Is a pity..I lost the only useful data ...:upset:

Thanks for your comments ! All props have carefully balance both axes ..i think that to make upgrade again for me is a nightmare ..no more thanks !!!as you can see in the picture above i have almost 2 years with very successful flights without a single problem...this is happens right after the...

Stacky ...i will try to day to make this flight log but i am think that is lost because i have done a second flight after that with older firmware so my first flight with the problem has lost ?