Search results

Correct. But Update FW doesnot become available. And again, Skyline reacts in a weird way when powered up (turning connection on idles the servo's, led turns blue, servo on/of no more available, get warning to upgrade firmware, disconnect doesn't work, led stays blue...). So there is...

jffry, that doesn't work... Under the Firmware Update - tab I only have a box "Restore to defaults" which is greyed (not clickable) and no box Firmware update that I can click. However, I get some sort of connection when I : 1) power-up the Skyline - green led Then the roll servo starts turning...

I had the same problem with very same symptoms as jffry. However the problems persist in FW 2.4. If connected to unpowered Skyline I get "failed to connect" and in the lower right corner "Com port connected / Skyline disconnected". If connected to powered Skyline "Upgrade to 1.2.1. to use this...

Fifon, why don't you buy a Wescam then for your 'television' and 'advertising' jobs?

Hi Clint, If you perform 'set level' and then 'auto tune' the servo's need to be engaged physically and in software. For setting level the Skyline measures the exact desired values of a level platform, and uses this for reference. With 'auto tune' a test is performed to calibrate the gimbal...

Clint, you have to do this: 1) With all power off, connect the Skyline with the USB to your computer. Set all gain sliders to zero, and servo's powered off (also in the software) 2) Open the software (to be prepared) and make sure that you have no (software) connection. 3) Power on your Skyline...

I bought a replacement at rs-online.com

This test was done with a GoPro; and I would say that a GoPro is just at the lower end of the benchmark given its very wide angle and light weight. I would like to see a test with a heavier camera and and a less wider lens with in-camera stabilization switched off. So I do agree with 1001...

Erratum: The limits do work, however only on tx/rx input. It doesn't limit the stabilizing itself. Must be a bug....

Reddinos, try this: - adjust centre levels, than confirm with 'set level' - next "power off" in software (so keep power source connected). The tray will jerk a bit and stop. - than: save your settings. - "power on" again, ( Servo's will engage again, putting the tray to the level that you than...

Yes you can! And of course, the whole stabilzer would not be worth a penny I you couldn't! Don't you want a perfect horizontal horizon? The slew mode is let you adjust the level, and it will keep level. Having setet my Skyline with Graupner receiver didn't work on roll (tilt did). Changed to...

And what if you just use the pulse wire from coming the FlightCtrl , and set the compensation in the MKTool to zero?

Hello Dave, I am flying a Droidworxs ADX4-HL with Photohigher AV 130. Mostly in combination of Panasonic HDC-SD800 with 0.7 wide-angle lens, adding some 250 grams to the total of 350 grams of camera. I have the CGV of the camera lined-up with the CGV of the gimbal (CGV falls in place with the...