Search results

I have a heavy lift X8 multi-rotor with 8 Tiger U8 motors and 26"CF props. It has six motor wire for each boom (3 for the top and 3 for the bottom motors). Each wire is about 28" long, give or take. I'm currently looking for some weight improvements so I was considered replacing the 12 gauge...

Never been opened. Gone to a HL 26" Carbon Fiber build and are no longer needed. $125 USD for all 5 pairs, plus shipping.

I currently own a very nice SkyJib 8 HL but can only get about a 9 true minutes of flight time, with a 8,000mAh and a GH3 payload. I’m now looking to build a new machine that will give me longer flying times for my doing infrared (my main business) scans of solar farms. I was thinking...

Ok. DumbA$$ move I know. I was removing a tie rap and managed to nick 1 wire, within the IMU cable. Nothing else. Am I going to fell a lot of pain if I just solder and shrink tube that one wire? Is there going to be any signal issue(s)?

Does anyone know where I can get a cable to go between my Panasonic GH3 (AV out) to my DJI 5.8 Video Link transmitter?

My SkyJib 8 (v1) is now flying and I'm just finishing the setup of my Cinestar 360 Gimbal with the 3-Axis Radian. I now need to connect the two. Anyone out there with this combination and if so, how did you connect the two? TIA Rick

I am using the Maytech 85A ESC with my AXI 4120/20 motors. When everything is connected (transmitter, receiver, ESC) I get 6 beeps from the motor (6 cell battery) followed by 2 beeps (brake off) as it should be. Everything should be ready to start by using one of the combination stick...