Search results

Hi Halfpipe Thanks for this information. I didn't know the existence of this product.

Hi, thanks for your suggestion. I finally bought a Nikon P310. It has speed priority and AV out. Sony RX100 seems a very good camera but I was afraid with Hdmi : it is necessary to add a converter, with cables and power it. I prefer a simpler solution. Thanks Mario

Hello, I'm new to multirotors. I would like to take aerial photos for my Quad X. I'm actually using a Nikon S4400 : the photos are often out of focus. The camera do not has a speed priority so even in sport mode, it is working at low speeds (ex : 1/600ème) So I'm looking for another camera...

Hello, I think I found what's wrong. First I connected the GEAR port of the receiver to the U port of Wookong MC. I think I red it somewhere. The motors do not start. After a lot of hours of trials, I disconnected the GEAR port and connected the X2 port of the receiver to the U port of Wookong...

Hello, I have checked the connections between DJI MC and ESC : the white wires (signal) face up. I think it is correct. On the TX cali screen when I move the transmitter's sticks, the sliders are moving in the right way. Juste one thing : the throttle slider is not totally on the left side even...

Hello Chris, first, once again, thanks a lot for your time :) I have done the calibration of each ESC without Wookong as you described. No problem : the 4 motors are operationnal. They power up smoothly from minimum to maximum throttle. I hooked them all up to Wookong and when the multirotor...

Hello Chris I put throttle stick in full position. Power up WK with ESC connected. I hear 2 bips (continuous) I move throttle stick to 0 position The 2 bips continue Switch power off and power on again The motors do not start but now there are 2 continuous bips I can not connect the assistance...

Hello, Thanks for your time. one beep is not the whole ready information : if I remove all connectors coming from the ESC to receiver, each motor beeps once each 2 seconds. But do you know if I must remove the red wires coming from the Wookong MC to the ESC ? I didn't removed this wire up to...

Hello, On a Quad X, I would like to replace a FC Multiwii Mega by a Wookong M. The problem is that the motors do not start. The wiring of Wookong modules seems ok. In the DJI Wookong assistant: TX calibration is ok, the 3 cursors are green The AR8000 lamp is on so the binding is correct The...