Search results

I got a reply i will past it below. It seem to be acting pretty well. I keep having to go to normal mode to catch it when it runs off. But for the most part it is ok. Not safe to use near other people. I have been trying to buy a HoverFly Pro for the last week now but Ben at hoverFly has...

MoneyHunster, Did you need to upgrade the ESC's or Motors for the WKM? Also can the WKM run the gimbal and all 8 ESC's? I have heard that it only has 8 outputs. How did you get around this problem?

Browley, Yes I sent an email to XAirCraft and yes you are correct about what he wanted me to record. Below is a link to what i recorded. I have emailed Jingchen with XAirCraft support@xaircraft.com. As you can see from the video only the yaw it drifting this time. I do not know what it is...

I received a reply from XAircraft. They asked if I "could you take a video of the oscilloscope? selecting the pitch, roll and yaw rates. after calibration, the rates should be wave near the zero." I do not have access to an oscilloscope at the moment but if some one on this thread has one and...

Well Folks I will need to find a different source for flight control on my x650v8. I have not received a reply from the Xaircraft so far. I do not wish to sit back hopping that they are working hard to fix it. In my mind I payed for a working product. I am very happy with the airframe as a...

KilBy; It looks like the SBus only works with a Futaba transmitter. I am currently using a JR 9303. Have you seen any solution that would allow me to use the JR. Airaid John; Do you have an email adress to the XAircraft rep above. I would like to see if they will replace my AHRS gyro. I...

Well i am ready to buy the DJI system but I read some where that it can't handel all 8 speed controllers and the camera servos do to only having 8 outputs.

Jzquad; I am using the same firmware as you and I also have the same setup with the GPS and compass. Are you using this version of xaircraft center http://www.xaircraft.com/wiki/XAircraft_Center(en):RC_Settings Topflight; I to have had varry little luck with return home. Last time I used...

I took out my 650v4 today with the external BEC installed and all ECU BECs disabled. I also hooked up am amp meeter to it. Max amps during full throttle climes were 43.2 amps. The FC seems to use about .2 amps at rest. The stock ESC's are rated 10 amps. I think some of the problem may be...

I have installed a 3A BEC set at 5.3v (stock BEC puts out 5.01v). I have some pics of the installed BEC below. I will test fly tomorrow to see if it makes a difference. Quistion: Has anyone used a 4s libo on the stock motors and ESCs.

One thing i did not think about when building is that all my ESC's have the BEC set up. I will try disconnecting the on board BEC's and use an external switching BEC. This should help keep the temp down on the ESC's and give me some more battery time. Dose any one know if the x650 v8 can...

I did a test today by putting my V4 to flight for 24 total min. I put it up in the air 4 times consecutively with only the time required to change out the batteries (6 min times 4). I took about one min to replace each battery. I used only NORMAL(NOR) mode in all flights. I did not see at...

John, I recently picked up an x650 v8 as well and found the same problem. It is now a v4 after the crash. It did well up to about 4 min of flight time then seemed to favor drifting to the front left. I had the stick rocked almost full right to keep it back from a near by fence. Once i...