Search results

Hmmmm, no love?? I have a problem I could use some advice on from anyone else who built a 680 pro with auto retracts. When I mount the auto landing gear, using the provided M2.5 30 mm screws.... I only have 1-2 threads to screw on too. Trying to find 35 mm screws is seeming impossible...

I only managed 8 mins on the 5000 6s I have (naza landed), was kinda disappointed with the flight time. Read some info on cold weather having negative affects on lipos... It's was -8 C when I tested it. Any help in the questions above is much appreciated :) cheers!!

Cool vid strike!! I wouldn't want to fly inbetween them if they are live, your rotor may become a bridge :(

Hey all, can't figure out how to post pics :( What's the general concencess on running 2 3s 5200mah vs 1 4s 10000 mah?

Thanks for your response strike!! Been really busy with work lately. Slowly picking away at the build as I have time. Been making crappie jigs and repairing rods as well. Going to try and post a few pics... I really appreciate everyone's help. How often in the field do you need to...

You guessed it!! Another question.... While hooked up to naza on my pc, in the basic tab, on the bottom its supposed to display your 3 modes alti/gps/manual (failsafe inbetween) I have alti twice and manual... Looking to take out manual for the time being and add GPS... Anyone know how? As...

Hey all!! What's the do's and don'ts for mounting your internal software? Can I mount my btu on the receiver, or my isod mini on my can bus? Curious if they'll cause interference with each other, or over heat!! Any thoughts are welcome. Thanks all, cheers!!

Thanks sleepy, that's the side I was looking to tape down (the flat side) took it all apart last night after making sure everything was working. Time to start final assembly (thread lock and braided wire sleeves) having a little trouble finding a long enough m2.5 screw to mount the auto landing...

I'm using..... » 6 x Hobbywing Multi-Rotor ESC XRotor-40A [XR40A_V1] Mounting them face down makes the build a little cleaner as I couldn't fit them under the motor mounts. Shouldn't be a problem then?

Ok... Probably a silly question... Does it matter which side of my ESC I tape/ziptie down? Thanks again for your time :)

Cancel that.... Figured it out!! Slowly but surely, learning a lot though :)

Have the pmu power supply soldered on to the battery terminal for now. Going to post the parts going into this build. Probably going to have a lot of questions, any tips/suggestions/pointers are welcomed. DJI NAZA V2 Multi-Rotor Stabilization Controller NAZA-M-V2 4 x T series 1355 Carbon Fiber...

Hey Carapau, thanks for the quick response :) Yes it also supports a 2-6s lipo My next question is, does it matter where on the board I solder it too? The + - from the pmu aren't very long, conjoining them with a + - for a motor might help with ease of installation if possible. all...

Green... That's me!! Tarot 680 pro/naza v2. The power supply coming from the pmu... can I solder it to my board, the same place my main battery connects?