Search results

I have not gone this far yet for my 360 but I had the same thought, If plugged into pan as programming mode there is no way to test the gains ( with the camera radio) or center offset of the pan servo unless one plugs and unplugs the servo back and forth with the programming cable.. I would have...

Ok, I will try that.. when in slew mode I have to move my pot over halfway before it starts to move at all. What mode do you use? Did I do the right thing in removing the red wire to the tilt input?

Tilt question.. ? Using Futaba T10 CHG when I set remote input and put it on a variable pot on the radio ( SLEW MODE) I can go from 0 to 90 with a very smooth movement, I can adjust gains for speed I like. But!!! I cannot go halfway or anything in between as the gimbal wants to keep moving to...

well i did it, still makes some noise but it is not moving like before, the movement is very minimal now , hopefully when flying all will be good. I will see tomorrow. good tip, thanks for the advice what are your gain settings? Might save me some trial and error on finalizing the set up

just leaving the office, I will do this when I get home, thanks

will try and do that tonight.

I just tried balancing and then also just moved the camera ( sony Nex5) around on the plate looking for a sweet spot and I get constant buzzing no matter where it is at.. The table is heavy wood sitting on a concrete floor.. The buzzing is driving me crazy :(

I just installed my skyline and av130 and the newest software. The only way I can get it to sit still is turning gains to ZERO! of course that is not paractical as nothing will move on roll or tilt. I tried 1 , I tried 200 and up especially the roll is in constant motion, the bubble never...

can someone send me a close up pic of the programming cable ( the end that goes into the skyline), I did not get one from the seller of my skyline. is the cable proprietory or can I get one local at an RC shop? Your thoughts on that? also it is not clear to where to plug it into the skyline for...

I will follow up on that no equipment, they told me they would and I just sent my app in.. we'll have to wait and get confirmation