Recent content by Spanky

Tiger 1806s on 3s using 5x3 props lift and haul butt with a GoPro without gimbal for 14 minutes now (AUW is about 600grams). As long as the added weight of gimbal keeps me about 7 minutes it would be worth it.

It's a Blackout spider hex custom designed by an Open Pilot member. It does in fact have an isolation or clean plate to attach the camera to but was looking for a gimbal small enough to mount to that plate to see how good of video I can get out of such a small platform. Didn't think I would be...

Come on with all the great knowledge in this forum no one has a recommendation for a small GoPro gimbal?

As the title says I'm in the process of building a Blackout Spider Hex which is 290mm. It is designed with a vin isolation plate on the bottom for a GoPro to record FPV flights. I'm wanting to possibly install a gimbal for a GoPro 3+ on the bottom plate for AP. I know nothing about gimbals so...

Lag1791 is this still for sale or sold?

The higher the stick scaling number the more sensitive the quad will be. It basically increases the rate of turn. If doing a flip with stick scaling on say 50 it will make a large diameter loop. If the stick scaling is set to say 80 the size of the loop will be much smaller and it will complete...

It's possible but give yourself LOTS of altitude because the loops or rolls are going to be HUGE! Have you considered cheating? Fly in atti mode then ready to flip or roll flip your switch to manual mode, complete the loop then switch back to atti just as it comes back somewhat level. I would...

Wow I was excited to finally find a thread with the OP having the same exact issue but seems nobody has any ideas.

Had the same problem and the solution was STUPID!!! I use a JR 9303 with Spektrum 8 channel RX. Everything was set up correctly and showed that all controls were moving in the proper direction in assistant, however, just by chance I noticed that if I applied ANY downward pressure on the throttle...

I'm having the same problem with a Naza M. I got both used from different people. Goes great until I finish the vertical and get red LEDs. I finally gave up thinking the GPS/compass was bad. Something else I noticed that I'm curious if you had the same issue is on the gain tab it doesn't show my...

Completely built NEW Axial EXO Terra roller. I got a new kit and built it. Decided I wanted to move back to RC flight. Kit was completed but never run. Has not even had any electrics mounted! I did not paint the body so you can add your custom touch and make it yours. Comes with 6 LEDs mounted...