Recent content by Shawn Herold

We go SDI out of the Camera and into a SmallHD screen mounted to the rails and go HDMI out to either a paralinx arrow or DJI lightbridge.

Our Gh4 Gimbal was doing the same thing. I stopped tightening the screws that mount the camera as much. I just make them snug but I don't over crank them and it stopped the bad vibrations.

Cinestar 6 DJI WKM Avroto M2814-118 Motors Turnigy Plush 40 ESC Spektrum Receiver RC Rotors 3 Axis Gimbal Alexmos 32Bit board w/ Bluetooth iPower GBM 5206-150T Motors. $2,000

We use the ronin on almost every shoot and the first few shoots it was a bit heavy especially coming from using movi's and Alexmos gimbals. Now I can run a DSLR all day with no problem and a C300/C500 all day with breaks. As far as the software and the performance I actually prefer it over the...

Unfortunately you currently cannot have the slave device transmitting also. I wish you could so you wouldn't have to be tethered to the other op. We just use the second LB for either client monitor or so the pilot has a screen along with the cam op to do better tracking.

Did you turn off the RF function on both controllers?

What is your reason for wanting to run the gimbal alone on lightbridge?

No problem. They also have the Arrow X if you need some more range.

Why not use something like a Paralinx Arrow since they make one that uses HDMI instead of SDI? Also what exactly are you trying to do?

I second that. Once you shoot with the system long enough you can take the camera off, switch out a battery or card, and have it back up in the air within a minute.

What are you needing SDI out for? We used our S900 for a livestream at a concert and we came out of light bridge, into a HDMI - SDI converter then when into the video switcher. We had the lightbridge set to realtime at 720p but recorded internally at 4k.

Since the inspire 1 controller has built in lightbridge do you think you will be able to pair it with the lightbridge air system on a S900 / S1000? Would be a great all in one controller and I wonder if this would make dynamic RTH work on the S900 / S1000

Once the reset it successful you will see the gimbal in your assistant software. Update the software again then power cycle the heli.

I don't think that ios 8.1 is the issue. The devices that already had the lightbirdge app on it worked fine for about 5 days before it quit working on Friday. Any device that we first upgraded to ios8.1 then tried to download the Lightbridge app it would fail during installation. We also tried a...

Have you tried to hard reset it by jumping it? Use either a wire or something metal to jump these two pins