Recent content by Photohigher

Hi Guys, We have been really busy with the Halo gimbals which we are finally getting ready for the first production run. We have also been experimenting with a brushless conversion kit for the AV200. This is a three axes bruchless conversion - it is nice and compact and we have tested it with...

We sent the Halo 8 and Halo 2000 up to a company in Hong Kong who were at the BIRTV show in Beijing this is a short clip from the show - http://vimeo.com/73279772

SMC - there is another option with regards to the psot above and that is to remove the potentiometer from inside the servo or you can replace the Pot with two resistors around 2.4k and this will also make a 360 servo. The link above shows disconnecting the little coupling that connects the pot...

We do notnormally supply the 360 kits assembled so i am not sure why the nut is tootight - unless you purchased this from a re-seller? In any case the nut shouldbe tightened just enough to remove the slop - with lock tight. The 360 kits areassembled by the customer - majority of the time. Thrust...

There is no other pot inside - I think it must be the pot itself that is faulty especially if it has spun more than 180 deg

Maverick to get the circuit board out you need to remove two little screws on either side of the motor. To get to these screws you need to remove the top case of the servo and they are under all the gears It sounds like you may have tensioned the cable so it would be best to check you could...

Maverick can you also check inside the servo to make sure the pot lead has not come loose or the solder has come away?

Hi guys It sounds like the pot is damaged. To make sure can you use one of the other pots from either the roll servo or tilt servo - depending on which servo is playing up The pots are quite sensative and it they are over turned etc they can get messed up Can you also make sure the pot...

Hi Guys and Happy New Year! Realy looking forward to getting back to work; we are officialy back at it on the 7 January which is tomorrow for us here in NZ. We will release the v1.5 firmware if there are no issues being reported. We will check feedback from our beta testers and then it should...

Thank you Dave and Ken for the assistance. Nick i appologise for the not replyin to your e-mail. I have checked the info at Photohigher email account but we dont have any email from you waiting there. one of the sales guys may have replied, i know from experiance some emails do get blocked...

Hi Topflight,The only issue that relates to us would be that the holes have not been countersunk.as Milo pointed out we did have a problem last year but these were all fixed.We did have a short run of about 30-50 gimbals this year which the guys inassembly missed the countersink however we did...

Please can you give us some more deatisl on the issue you are having.If everything is assembled correctly there sould be enough space for everything. Images will helps see what is causing the issue. Thank you, Kim

Ken, If those sharp twitches were not there it would be pritty good, it could be the isolation however i will talk to Brendon on Monday and see if there is somthing we can do with the code. This is a nice video doen with A Skyjib AV200 with Skyline - there is some postabilisation however it is...

Just a quickupdate to say we are finally making some progress. You saw the video weuploaded on Friday with very little wind. Today we did some more testing andmade a few changes. We are just uploading a couple more videos from today; onewith the AV130 on a DJI F550 and the other is on a SJ8 with...

Just a quick update for people we have made a new pan shaft for the Av130 with a longer thread as well as a hole through the shaft so the nut can be secured with a split pin this way itf the nut come loose it can not fall off. Please contact your closes distributor if you need to get one of...