Recent content by Phil550

I have the SkyRC Quattro B6 and have a similar problem. After an hour of balance charging my Turnigy 5000 mah 4S lipos read 4.20, 4.19, 4.19, 4.20 (all 4 cells switching between 4.20 and 4.19) but the charger doesn't always shut off. Sometimes it can go to the 120min limit without ever switching...

Having read various posts that said that the H3-3D would work with the Hero 4 Black, I decided to risk it. However, having updated the software etc it works, after a fashion but all 3 motors make a loud buzzing noise when working. I assume that this isn't normal or is it? Could this be due to...

Have a look at Final Cut Pro X and these training videos: http://www.izzyvideo.com/final-cut-pro-x-tutorial/

On page 6 of the Naza M V2 Quick Start Guide it does say: 'For big aircraft that is larger than 650 or with heavy load, WKM is recommended' So it could be this....

I've just bought one of these and it weighs 62g with the battery. Where have you mounted yours - the top plate of my 550 is a bit crowded... Thanks Phil

FCP-X. Check out the Izzy Tutorial videos: http://www.izzyvideo.com/final-cut-pro-x-tutorial/

Has anyone tried one of these: http://www.back2you.com/personal-gps-satellite-tracker.html Phil

I had the same problem with my Naza V1 and DX8 after updating the firmware. It may have been a coincidence but the "CFG-ERR" disappeared after I calibrated the GPS and I was able to re-calibrate the TX - might be worth a try.... Phil

I'm going to change my F550 (also 2.4kg) from 3S to 4S - can you tell me what your gains are set to? Thanks Phil

Video shot on the island of Tiree, Western Scotland in October. Still learning to fly (must stop making small course corrections when flying in a straight line..) and video editing (FCPX is excellent...). Last 3 stills were taken with a Canon 7D + 10-22mm and 100-400+1.4 ext. C&C always welcome.

Thanks for the link - great videos! I've been using iMovie but it doesn't handle 1080/60 clips very well and it appears that you have less control in the latest version. I'm using a Macbook Pro (2011, i7, 8gb ram, Mavericks) which is ok but I get the occasional Quicktime error 50 when rendering...

I've just started using the trial version of FCP-X : can you tell me which GoPro plugins you would recommend? Thanks Phil

Me too, except with DX8, AR8000 and Naza V1....

I'll stick with the Spektrum - as you say, lots of people haven't had any problems. The only reason I'm considering the AR9020 is that it has 2 remote satellite receivers which should maintain a better signal.

Thanks for the responses. I can't find anything obvious that is wrong so I think I'll replace the RX as a precaution - is it worth upgrading to the AR9020 from the AR8000?