Yes I did them individually and got a confirmation tones on all the motors. Now I have another issue. When I try to arm the motors, they do not start up but if I throttle up to 50% they start to spin.
My build is:
fy680
DYS SymonK 30a
Nada M v2
4c battery
Spectrum DX9
Spectrum 8000
My problem is that when ever I start up the motors I will only get 2 or 3 motors to start up. When I throttle up to about 50% the others will start up. I have read that I must first calibrate the ESC's. How do I...
It is stable in all angles when not moved from the straight ahead position. I mean. when I fly around the picture is smooth a forward facing. I only the the hopping (vary slowly) when trying to pitch downwards.
My Tarot T-2d will not hold still when I am turning the knob to tilt go pro down wards. It tilts to the chosen position and stops and the bounces wobbles up and down vary slowly. It will not stay still at any angle except in its home. Has anyone had this happen?
I was told by my local hobby shop to update my Spectrum DX7s to v. 1.06, I have v. 1.03. But on the spectrumrc.com site they only have a listen for 1.03, is there a 1.06?
I have a DJI f450 that has been upgraded with extended arms now my f450 is an f550 with sill 4 arms. With first test flight it is more stable and response is quick. I was wandering if I could use a different motors with longer props to make it even better. Use of my copter is for arial photos...
Took another look at it and found out that during the unsoldering and resoldering, I must have heated the board too much and lost contact in the positive side from the battery contact in the board. I happened to have a spare board and redid it and now all is well.
I just took apart my DJI f450 to replace with extended arms. Turned my 4 arm 450 into a 4 arm 550. After resoldering everything back together I notice first that the Naza hardly makes the start up tone that I am used to. The second thing is that I cannot start up my motors. (both stick to the...
Wow. maybe replace the arm with longer ones.....3.1kg AUW.....
But the way, what would be the largest motor to install on the f450 without extending motors mounts?
I have a DJI f450. Love the thing. I just broke an arm during one of my stunt flying. I was thinking, instead of replacing the one arm I would get just the frame of a f550. Purchase two more motors and speed controllers. Then I would have three arms as spears and a copter with more lifting...
It's been raining off and on for a couple days. While I was installing some landing legs and checking the Naza Assistant I noticed that the number one arm/motor should be turning CCW and the the number two should be CW. Well I had them, One going CW and two going CCW. So tonight I changed them...
Ok. To answer all the questions. I have setup all the assistant calibrations. I did input the location of my GPS puck head (x=-4, Y=4, Z=-10) right rear arm. I do the naza dance at every location. It does fly but if left alone in GPS hold it will start to hover around slowly around making a...
If you mean the gps calibration? Yes and it was successful. Otherwise what other sensors are there to calibrate. Sorry for the basic question. First multi rotor.