I will assume you are not flying a DJI Multirotor......
Are your ESCs matched to your battery voltage and your motors?
Did you cofigure each ESC for the full speed range while connected to each motor?
While unlikely to happen in 2015 I am hoping that, someday, manned helicopters over cities are banned and replaced with small UAVs, with the exception of those required to transport passengers and/or heavy payloads. Not only would this be more energy efficient but, in the event of flight...
Sounds good...... whereas there are some nice new features in 5.26 I only tried it on a build for a friend and for some reason the MR immediately crashed so I lost faith.
As I mentioned before I had great success with 5.20 but then sold my MR.
Lots of reported issues with firmware 5.26.......
You won't find many, if any, complaints about fw 5.20.
In my case I flew my hex for over 150 flights w/o incident, then sold it and the buyer completed over 100 flights w/o incident.
May I suggest you roll it back to 5.20 and try again.
What do others on this forum think of this concept? IMHO - At this time a remote landing even with waypoint would most likely result in a crash and there is the risk of hitting someone at the landing area. But it might still be possible to remotely lower and release the AED at the target location.
Yes.... seen much of your coax work before from Austria including GPS waypoint missions etc.
Are you aiming for super long flight time or designing for heavy payloads?
That link is for a 3 axis BGC....... yours is a the more limited but easier to configure 2 axis BGC for pitch and roll but no yaw rotation camera motor. You rotate your MR for camera panning. Your product seller is responsible for providing as an absolute minimum at least all required...
Yes a production fault IMHO.
I had one of my Turnigy 45 amp OPT ESCs fry the first time I powered it up for the intial bench test...... (that was one in approximately 20 that I have used over the past couple of years).
I always test new electronic components as soon as they arrive...