Recent content by gadget

That´s what mine did a couple of times but more lika a pendulum motion bigger and bigger until i aborted (under gps) The day i crashed i just calibrated the compass and thought everything was fine, obviously it wasn´t and i found out the hard way! :O(

The system that i crashed with was the old one. I have another one but had to send that gps back because of some problem with firmware!

Hmmm, i have maybe 50 hours of flight time with this machine and i trust it completely but this was something new. I´m 100% sure there´s nothing wrong with anything else and i know there´s nothing wrong with the motors etc.! The only way i can explain it is as if the wookong suddenly though that...

I also had a flip and a crash on my wookong after upgrading to 5.14. Most of my big okto is now crap incl, kamera, downlink, battery etc. I checked all of the esc´s and motors after as well as battery voltage and they´re all ok. F**k!!!! This wall all under gps-mode and it wouldn´t straight up...

This is ridiculous. I´ve spent so many hours trying to get mine to work properly but i´ve lost my hope and i´m sending it back today. Releasing a product like this with all these issues is a joke. There can be bugs with a product, i´m aware of that but the Skyline is not close to a finished...

anyone know where to download older firmwares for the skyline? it´s not available on ph homepage!

Anyone know by the way where i can download firmware 1.1.3 for the skyline? It´s not available on ph homepage!

I´m certainly not en expert since i haven´t got mine running yet beu the problem with the tilt causing a slight roll might be because the gyro is not 100% perpendicular to the tilt axis. If it´s off by just a couple of degrees it will affect the roll gyro by the same amount of degrees!?

Hmmm.... strange. What could be wrong then? I supply them through a bec at 6.1V 3A which should be more than enough! There is no other setting than gain to affect how they behave is there? This is what it looks like, seems to be more than 0.03s response time here? :upset...

So based on the below data a MKS servo won´t work? Savöx Savox SC-1256TG Dead band width: 3 μsec Pulse width range: 800→2200 μsec MKS HV787 Dead band: 0.0008 ms (Default) (0.8μsec?) Working frequence: 1520μs / 333hz Is there any way of making it work without buying new savöx servos?

Hi! I just recieved my Skyline and spent 3 hours trying to set it up yesterday but cannot get it to work properly! This question/solution might be in this conversation before but the thread is now 80 pages so i just cannot search them all. My problem is that the servos respond incredibly slow...