Updated P4 RC with HDMI mod. First start Go app... updates RC firmware (1.6.0). Rebooted...All good. Changed trans setting to simultaneous output. Everything works, outputs to both iPad 4 mini (running app) and external monitor.
Shut everything down and reboot RC and get alarm that RC needs...
Thanks. Tried that a number of times and confirmed by green light -sbus channel. The control mode switch on the NAZA-M-V2 channel U is not coming through the sbus channel to the receiver and TX 3-way switch.
Thanks for your reply, Paul. Yes, I can run in the "traditional" mode and connect each channel. That's what I'm doing now, and that the 2 Aux channels out of the NAZA go to CH 5 (flight control mode) on the receiver and TX 3-way switch. The other Aux out of the NAZA goes to CH 6 (IOC) on...
Has anyone setup S.Bus / D.Bus connection on the Futaba 6K with a Naza M V2 flight controller?
I can not get the Flight Control Mode to come through on any switch/channel.
X1 on the Naza comes into the Futaba on CH5 - I can assign to a 3-way switch but does not control flight modes
X2 on the...
Throttle stick issues with setting up the Futaba 6K and Naza V2 flight controller. Any thoughts?
I initially had issues using the s-bus channel in that I could not get the "control mode switch" to work on any of the Futaba 6K switches. So I went to the traditional wiring interface. Through the...
Issue setting up the Futaba 6K and Naza M V2 flight controller with S.BUS
Has anyone setup S.Bus / D.Bus connection on the Futaba 6K with a Naza M V2 flight controller?
I can not get the Flight Control Mode to come through on any switch/channel.
X1 on the Naza comes into the Futaba on CH5 - I...
Has anyone had any throttle stick issues with setting up the Futaba 6K and Naza V2 flight controller?
I initially had issues using the s-bus channel in that I could not get the "control mode switch" to work on any of the Futaba 6K switches. So I went to the traditional wiring interface. Through...