Bart,
Does this tool press the bearings on the O.D. of the outer race or does it push on the entire bearing? In other works does it have a rim/lip on the pressing face of the face of the tool?
Thanks,
Jeff
Congratulations! I remember my first solo, my leg was shaking so bad I thought I wasn't going to be able to do it. After I took off it was all smiles, that was 1997. Dang I'm old. I also remember my first solo in a helicopter, I was grinning from ear to ear.
Good job.
Jeff
I have found that typical extractors don't work well at all. Go to Sears and get the one pictured below, specifically the ones on the left side of the case, (in the picture below). I have removed some VERY small screws with them. The heating will help too, but you need very localized heat.
Lauren,
Thanks, I figured as much.:apathy: I work with a guy who is a very sharp cookie and has a bit of RC experience, he and I tossed this around for about 2 hours and didn't come up with anything conclusive. At least it killed some time on our flight across the country.
I have also had no...
On pages 20 and 21 of the Naza M Lite manual it talks about motor idle speed. I am trying to understand this section and could use some more information.
I have my setting on recommended and it flies fine. Why would I need/want to change it to low or high and how would that affect the...