Recent content by Angus

Pretty much finished, building a case/box for it to make transport easier, i am also aiming to sort out an FPV setup. The arms are not held in the conventional way, they are secured with a thumb tight pin. The gimbal is detachable and on only one axis due to multitude of electrical faults. h.

I'm building it at my friends workshop so I cannot show you what I have done so far. I am drilling through the center of the rear arm and inserting a rod. Then a spacer ocer the rod to allow for the servo couplings. The rod fits into two ball races/bearings inside a block, on which the motor is...

Hi I'm Angus and I have just started my first tricoptor build. I plan to make it neat and preferably look good. If you have any tips, feel free to post them below.

Hi I'm building a tricoptor and would like a cover for the electronics, I seem to remember an orange cover used by David Windestal on his tricopter. However I cannot find it anywhere, I have looked on Google images, the flite test website and almost every flitetest video. I was wondering if...

I just checked out specs and wiring and it seems ok, i think it must of been a short, maybe touched something. I need to be a lot more careful when handling electronics. Thanks for your help, it will be good to see what other people choose and how it worked out for them.

Thats an amazing bit of kit but too expensive. I am only looking for a gimbal for my GoPro.

Hi, I'm building a gimbal for my quad. I bought BGC 3.1 controller and connected everything up. It worked for a while and then stopped. I ordered a second which similarly worked and then broke.(On closer inspection one of the micro processors on Motor 1 output has a small hole blown out of it)...