Recent content by aForcefulThrust

  1. A

    KDE Direct has added Multi-Rotor Heli motors to their lineup

    Well the problem is the ESC is built In to the arm.. But the ESC is 40a and 6s so Im OK there. Just have been reading about these timing and loose sync issues and was hoping an ESC genius could tell me why it would or would not work. I have the motors now I can bench test in a few days when I...
  2. A

    KDE Direct has added Multi-Rotor Heli motors to their lineup

    I have the KDE 4014 380kv motors I'm planning to install on my S800 frame. Does anyone know if the DJI ESC's would cause problems? Unfourtionately I am limited on ESC choice with an S800 because of the way the ESC's mount to the arms..
  3. A

    6 SunnySky 4112 320kv motors

    I bought a RCtimer S800-R clone, that comes with motors so I just don't need them. Trying to make some of the money I spent on them back. I really like them as motors. They get about 16 min flight time with 10000mah 6s and a nex5 camera/gimbal and with 15x5.5 props. Absolutely nothing wrong...
  4. A

    6 SunnySky 4112 320kv motors

    Selling 6 4112 320kv SunnySky motors. Flown less then 10 flights, great shape. Comes with bullet connectors. 200 bucks gets them all shipped in the US! PM to buy
  5. A

    SOLD!!**RCT800 frame with landing gear and LED's

    Selling my old RCT800 frame with landing gear and LED's. Frame has over 50 flights on it, never crashed. Good shape. 100 bucks plus shipping! I also have 6 4112 320kv sunnysky motors I was using on this frame, an extra 200 bucks gets those too. PM to buy
  6. A

    Selling 6 iFlight iPower 2814 750kv motors brand new - $100 shipped

    Selling 6 brand new, never used iPower 2814 750kv motors. 100 bucks (firm price) shipped to the US - For International, buyer pays shipping too PM or post for offers SOLD!!!!!!!!
  7. A

    another crash with wookong

    That sounds right... but i also lost control of all other movement too. Im still stumped on this. i was using sunnysky 4112 320kv motors. Ive used them for plenty of flights before this happened, they were always warm but not hot on landing Sent from my DROID BIONIC using my fingers
  8. A

    another crash with wookong

    Thanks for the input guys. That does not explain why it tried to take off again by itself after it landed hard and the gimbal snapped... :/ i am still in the process of replacing all my components, a new rx is on the way. All new motors and speed controllers now too. The only thing that will...
  9. A

    another crash with wookong

    My plan is to replace my power distribution board and all ESC's. This should confirm either a wookong problem or electrical problem. Since it's allot cheaper to replace ESC's and my power board I'll do that first. After that I will strap the hex down and empty a few packs on it to see how it...
  10. A

    New HD streaming for MR

    Any router you can load DD-WRT firmware on can work as a repeater. DD-WRT will turn your 50 dollar linksys into a very capable router. You can also use 2.4ghz boosters if you want. http://www.dd-wrt.com/site/index
  11. A

    For Sale: AeroXcraft VTR125 gimbal

    After many months of use, i'm selling my aeroxcraft VTR125 gimbal. The gimbal has given me many good shots from my extended F550 helicopter.. The gimbal was involved in a crash, however the servos are all fine with no stripped gears, and all materials in the gimbal are still good. The only...
  12. A

    another crash with wookong

    Thanks for the input guys! It very well could be a short or bad ESC i suppose, the motors surging in power was very weird. What steps could I take to find out if that is the problem? what has me worried is the complete loss of control I had over my hex.. even manual mode was unresponsive. It's a...
Top