Do or don't remove the red wire on the ESC's?

[Jesper]

I'm setting up a X650 V4 with the DJI Naza. Should I remove all the red wires comming from the ESC's, do I leave 1 connected as I did with my KK5.5 multiboard?

I have bought ESC's that can handle up to 4S, the Naza can take up to 6Ss, do the Naza have a build in BEC, so that my RX don't get fried?

Thank you

 

[vinnygogo]

you have to cut all the red wire's. the led unit is a bec and puts out 5 volt for naza and receiver.

 

[Jesper]

Thank you

 

[Gunter]

Don't cut them, just disconnect them and heat shrink over the terminals. You never know if you will need to reprogram them again!


Regards,

Gunter.
Sent from my iPhone using Tapatalk

 

[Jesper]

Yes, I figured that would be the best solution Thank you