WKM and futaba sbus

[vip]

I have a futaba T10CHG radio..
with the R6208 s bus receiver and WKM... for the life of me I cannot figure a way to program FS with the WKM.. I set the FS for throttle on the radio at 46% but when I trigger FS hooked to assist software I do not see the throttle change like it did with the orange FrSky I had before.

I have also tried not hooked up to the assist software planning on hold it down ( with a board of course)
tried turning the radio off and flipping the switch to fail safe in the assit software but nothing happens.

My radio F/S setting show that I have F/s on the throttle but no go...

any Ideas anyone? or better yet experience?

 

[steph280]

You are supposed to set your failsafe on the mode select switch, not throttle. You basically want the mode select channel to jump to around -35% servo travel when failsafe occurs. However, then this condition occurs, your throttle needs to be held at > 10% as well.