Gimbal control reacts too slow

[fritz99]

Hello !

My two servo outputs for the gimbal control on the DJI WKM react too slow.
They are working, but when the copter makes a move they react too slow so the camera is not always in the correct position.

Is there a parameter to make the gimbal control react faster ?

Fritz

 

[Bowley]

I have a Naza and was surprised to see there was no input for refresh rate like there is on the XA software, I have no idea what its default is but from what Ive done so far I think the XA FC1212 + AHRS performed better in the gimbal department.
What speed are your servos? I had to upgrade my roll servo to a Savox hi speed, hi res (1258TG type that come as stock with the PH gimbals). this made a lot of difference. Still nowhere near acceptable yet except in no or very light steady wind when gimbal stabilization is barely needed anyway.

 

[fritz99]

I have a Naza and was surprised to see there was no input for refresh rate like there is on the XA software, I have no idea what its default is but from what Ive done so far I think the XA FC1212 + AHRS performed better in the gimbal department.
What speed are your servos? I had to upgrade my roll servo to a Savox hi speed, hi res (1258TG type that come as stock with the PH gimbals). this made a lot of difference. Still nowhere near acceptable yet except in no or very light steady wind when gimbal stabilization is barely needed anyway.

Thank you for your answer.
I also have SAVOX 1258TG high speed servos.
This is not the problem.