Nothing to do with dji but my rig is dji... Spektrum rx help

E

Elliott000

Member
I have bought a tm 1000 to go with my ar8000. It will bind ans function fine, but if i power everything down then on again it is not keeping the bind, rx/sat have a fast blink WKM shows fast red led for no connection and no response from radio input, rebind all is well power down, repeat lol
Thanks for any help....

Sent from my GT-I9100M using Tapatalk
 

W

WillM

Member
What process are you using to bind the TM1000, AR8000, and Tx? The process is different.

You must bind the TM1000, AR8000 and Tx all at once, using the recessed bind button on the TM1000.
Connect everything up, press and hold the bind button on the TM1000, power up the receiver, then power up the transmitter while holding in the bind button on the transmitter.
 

E

Elliott000

Member
Suggested from helifreak that i bind with no sensors plugged in, did that, powered down plugged in volt and temp powered up and all is well. Thanks for the insight tho

Sent from my GT-I9100M using Tapatalk
 

You must log in or register to reply here.
Top