I'm stuck. Can't set up Naza 2 with Turnigy 9x

[Flydigital]

Still very new to this and have just completed assembly of my DJI 550. I have got as far as binding (I think) my Turnigy 9x receiver and Tx. I have plugged USB in and that's where I got stuck. The transmitter does't seem to be working / connecting to the 550. There is a solid red light on the receiver so I believe it is binded. I cannot get any response or calibrate through the NAZA PC app. I have however got the motors to turn via the app so that part is working. Calibration of command sticks gives no response.Can anyone help here on what I might have missed? Thanks for any help!

 

[SleepyC]

Did you set the receiver type to PPM? There is a prompt that asks what kind of receiver you have in the DJI GUI.

 

[Flydigital]

Yes, PPM is set in NAZA-M V2 PC software and also on the Turnigy Trasmitter.

 

[PeteDee]

Sounds more like you do not have you USB port setup correctly.

Try rerunning the driver install and follow the instructions exactly.

Cheers

Pete

 

[Flydigital]

I actually got it working. I set it to traditional and not PPM. Not sure why it worked as everywhere I'm told it should be PPM.