Esky Belt CPX transmitter & receiver with DJI F450

T

touchwood

New Member
Anyone tried to calibrate a DJI F450 using an Esky Belt CPX (6 channel helicopter) TX & RX via the NAZA software Assistant ?


I can't progress past a CFG ERR 8 despite having re-installed the software, drivers and firmware.

The RX is an Esky 000731

The TX is an Esky ET6I

Does anyone know whether it may be possible to fly a DJI F450 using my above set up or do I need to go the Spektrum DX8/AR8000 route or is there an alternative cheaper TX/RX ?
​
 


T

touchwood

New Member
Hello Bowley - thanks for your reply. I have looked inside the battery compartment and I can see there is a small red module with 2 tiny white switches - no1 is down and no 2 is up.

I haven't noticed these before as the heli was RTF out the box. Will see if I can find out what these are in the manual. Thanks again.
 

You must log in or register to reply here.
Top